Procedure guide
Casts and splints: what to know before, during and after
How splints and casts differ, the risks, how they're put on, and the care instructions I'd go over with you before you leave the office in one.

The short answer
- A splint supports an injury on one or two sides and leaves room for swelling, so it's used first. A cast wraps all the way around and holds a fracture more firmly, so it's used once the swelling has settled.
- Keep it dry, keep the limb raised for the first few days, and never push anything inside to scratch. Pain that keeps getting worse, numbness or blue or pale fingers or toes need to be seen right away.
Bones, ligaments and tendons heal best when they're held still in the right position. That's the whole job of a splint or a cast. They look similar, but they're used at different times for different reasons, and most of the problems people have with them can be prevented with good care at home.
Education, not a consent form
This guide explains what a consent visit covers. It doesn't replace the conversation before your own procedure, or advice about your own injury.
Splint or cast?
A splint is a firm slab of plaster or fiberglass that runs along one or two sides of the limb and is held on with an elastic wrap. Because it doesn't go all the way around, it can give as the injury swells. A cast is a rigid shell that wraps the whole way around. It holds a fracture more securely, but it can't expand, so it's usually put on after the first swelling has gone down.
| Splint | Cast | |
|---|---|---|
| Shape | A slab on one or two sides, held with an elastic wrap | A rigid shell all the way around |
| Best for | New injuries, sprains, tendon injuries and simple, stable fractures | Fractures that need firm, lasting support |
| Swelling | Leaves room for it | Doesn't expand, so it's applied once swelling settles |
| Removal | Can be loosened or taken off to check the skin | Stays on until it's cut off in the office |
| Trade-off | Allows a little more motion; easier to take off when you shouldn't | Holds better, but carries more risk of pressure problems |
Who it's for
- Fractures, either right away in a splint or later in a cast.
- Bad sprains and tendon injuries that need rest in a set position.
- After a fracture or dislocation is set, to hold the position. See the guide to setting fractures and dislocations.
- Some overuse injuries, for a short period of rest.
Who needs something different
- Open wounds or skin infection under where it would sit. The wound is treated first, or a removable brace is used so it can be checked.
- Severe or rapidly increasing swelling. A cast would be too tight; a well-padded splint is safer.
- Loss of feeling in the limb, such as from diabetic nerve damage, which hides the warning signs of pressure. Extra padding and closer follow-up are needed.
- Unstable or badly shifted fractures, which are splinted for comfort and sent to a surgeon.
Benefits and risks
Benefits
Holds the injury still so it heals in the right position. Eases pain. Protects it from being bumped or re-injured.
Common risks
Itching, and skin that's dry and flaky when it comes off. Stiff joints and weaker, smaller muscles, which happen to some degree in everyone and recover with rehab.
Less common risks
Pressure sores where the cast rubs or presses, the most common complication. Skin irritation or infection, especially if it gets wet. Minor burns from heat as the material hardens.
Rare risks
Compartment syndrome, a dangerous build-up of pressure in the muscles that cuts off blood flow. Lasting nerve injury from pressure. Both are emergencies.
Know the warning signs
Pain that keeps getting worse, numbness or tingling, severe swelling, or fingers or toes that turn pale, blue or cold mean it may be too tight. Don't wait for your appointment. Get seen right away.
Alternatives
- A removable brace or walking boot, which works as well for some stable injuries and comes off for bathing.
- Buddy taping an injured finger or toe to the one next to it.
- A sling for collarbone and some shoulder injuries.
- Surgery for fractures that can't be held in position from the outside.
Step by step
- CheckI check the skin, feeling, movement and blood flow, and cover any wounds.
- PositionThe limb is placed in the position it should heal in. For a wrist, that's bent slightly back. For an ankle, it's at a right angle.
- PadA soft cloth sleeve goes on first, then two or three layers of cotton padding, with extra over bony spots.
- ApplyPlaster or fiberglass is dipped in water and laid on (a splint) or wrapped around (a cast). It warms up as it hardens. Tell me if it feels hot.
- MoldI smooth and shape it with the flats of my hands while it sets, then secure a splint with an elastic wrap.
- RecheckOnce it's firm, I check feeling, movement and blood flow again and make sure nothing is rubbing.
Living with a cast or splint
The short version
Keep it up, keep it dry, keep things out of it, and keep your fingers or toes moving.
- Elevate the limb above the level of your heart as much as possible for the first 2 to 3 days.
- Ice over the cast or splint for 15 to 30 minutes at a time. Keep the ice pack in a dry bag.
- Keep it dry. Cover it with a plastic bag sealed at the top for showers, and keep it out of the water. A wet cast softens and the skin underneath breaks down.
- Itching: never push anything inside to scratch. Objects cut the skin and bunch up the padding. A hair dryer on the cool setting blown under the edge helps.
- Move your fingers or toes often to keep blood flowing and joints loose.
- Don't trim or pull out padding, and don't take a cast off yourself.
- Pain medicine: acetaminophen or ibuprofen is usually enough. Strong pain medicine can hide the warning signs of a cast that's too tight.
- Coming off: a cast saw vibrates rather than spins, so it cuts the hard shell but not your skin. It's loud and tickles. The skin underneath will be dry and the limb weak and stiff at first, which is normal.
When to call
- Pain that's getting worse, or that isn't eased by raising the limb.
- Numbness, tingling, or fingers or toes that are pale, blue, cold or very swollen.
- A burning or rubbing spot under the cast, or a bad smell or drainage.
- A cast or splint that's wet, cracked, soft or loose.
- Fever.
Which procedures Peak Health offers in the office will be confirmed before opening. You can see the full list on the Services page, and the rest of these guides in the procedure guides library.
Sources: Boyd AS, Benjamin HJ, Asplund C. Principles of casting and splinting. American Family Physician. 2009;79(1):16–22. aafp.org. Boyd AS, Benjamin HJ, Asplund C. Splints and casts: indications and methods. American Family Physician. 2009;80(5):491–499. aafp.org.
Join the waitlist
Peak Health is not open yet. It opens for direct primary care in Colorado Springs after Dr. Bennett's Army service ends. People on the waitlist hear first and are offered membership first.
No payment and no commitment.
